So, during the "generous donations" side mission, Jyn uploads a virus to an imperial terminal, which causes all the doors of the facility to close and reinforcements, including an elite AT-ST, to arrive.

While Gaarkhan is outside. This is the second mission of the campaign.

The Gaarkhan figure's pose has never been more appropriate.

Don't worry ... the AT-ST doesn't have a gun.

Might not have the nose gin, but those ominous looking thingies on the sides are a bit disturbing

Might not have the nose gin, but those ominous looking thingies on the sides are a bit disturbing

It's only a model...

Yeah, I didn't want to spoil the reveal, so I hadn't assembled it yet, and then the gun wouldn't fit. XP

Yeah, I didn't want to spoil the reveal, so I hadn't assembled it yet, and then the gun wouldn't fit. XP

Haha, my ATST is the same way. I've yet to spend the time on getting the gun to fit.

There's a thread on how to do it elsewhere in the forum. Apparently the recommended approach is to put the gun onto the table and then slam the head down onto it. YMMV. XP

Dip the nose of the atst in hot water to soften it then stick the gun in

There's a thread on how to do it elsewhere in the forum. Apparently the recommended approach is to put the gun onto the table and then slam the head down onto it. YMMV. XP

I did that, sorta. Then my AT-ST had... some dysfunction getting his gun up. A spot of blue stuff fixed it.

Yea my AT-ST has a limp gun, wont' stay up. I need to glue it.

The funny thing about it is, it is Jyn and Gaarkhan, basically the Han and Chewie of the hero set. So i can see Han doing this and then Chewie being stuck outside roaring and beating on the door for Han to let him back in...hahaha....ahhhh...

~D

Yea my AT-ST has a limp gun, wont' stay up. I need to glue it.

They have pills for that now. Just make sure that if your gun stays attached for more than 4 hours to consult your nearest medical droid.

Hot water and pressure may remove the limpness too.