Hey guys,

So was moving flats and as I was just finished, accidentally knocked 2 models off my desk, an X-wing and the prototype A-wing. Unfortunately, they broke in one of the most annoying ways possible, off of their mounting stick with the tip still in (no jokes!). I was thinking of using a mix of blu-tak and glue to get them back on, is this the best way?

Many thanks

I hear using a pin vice drill and a small bit is the way to go about getting thoes out

Try heating up a small needle and inserting it into the broken piece. Then pull out once it's cooled off. Works every time for me

I think the best way is to replacement with a new model of the ships, if you glue it, you always see the parts, and it remind you the acident, so give it and replace, greettings.