Evacuation of hoth setup

By Jaden Ckast, in X-Wing

So I'm planning on doing the evac of hoth mission soon but wanted to go over the setup first and was confused on this part. Under campaign setup it states " the total cost of the rebel fleet cannot exceed 200 squad points. The gr-75 ship card and "combat retrofit" do not count against this total. Other upgrades equipped to a gr-75 still cost the amount of squad points indicated on those cards". Ok that's fine but then under mission H1: evacuation mission setup it says "rebel:gr-75 (combat retrofit), 125 suqd points" also under mission h2: blockade run it says rebel 140 squad points and then under mission h3 asteroid gauntlet it says rebel 125 squad points.

So why does the roster and campaign setup say not to exceed 200 points but then in all the missions your only allowed 125-140? Now I know th imperials get reinforcements but this is not the case with the rebels so I'm just a little confused. Do I make a list not exceeding 200 or 140?

All of the ships for the individual missions need to be pulled from your master "fleet" list. That list is 200 points. So you get 200 points of options to make your smaller lists from.

So for mission h1, you need to make a list that's 125 points. But, you can only make that list using the ships, pilots, mods, etc. that make up your 200 point list.

I hope that makes sense.

All of the ships for the individual missions need to be pulled from your master "fleet" list. That list is 200 points. So you get 200 points of options to make your smaller lists from.

So for mission h1, you need to make a list that's 125 points. But, you can only make that list using the ships, pilots, mods, etc. that make up your 200 point list.

I hope that makes sense.

Ok gotcha ya that makes sense thanks for the clarification. Also what about the turbo lasers and ion tokens? It says you place one during the end phase and the way I read it is it doesn't go away until someone rolls for damage from it right? So you could potentially have 2 on the board but only 1 activates which then clears all from the board?